Kia Optima: Removal - Repair procedures - Horn - Body Electrical System - Kia Optima TF 2011-2023 Service ManualKia Optima: Removal

1. Remove the radiator grill upper cover.

(Refer to the BD group - "Front bumper")

2. Remove the mounting nut and disconnect the horn connector (B), then remove the horn (A).


Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal. The horn should make a sound. If the horn fails to make a sound, replace it. Horn Relay Inspection 1. ...

Installation
1. Connect the horn connector, then reassemble the horn. 2. Reassemble the front bumper. ...

See also:

Description and Operation
Description The hydraulic system consists of oil, an oil filter, an oil pump, and a valve body (valves and solenoid valves). The oil pump is powered by the engine. ATF passes through the oil filt ...

Engine temperature gauge
This gauge shows the temperature of the engine coolant when the ignition switch is ON. Do not continue driving with an overheated engine. If your vehicle overheats, refer to “If the engine over ...

Inspection
Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor input s ...

Copyright © www.kiopman.com 2023