Kia Optima: Removal
| 1. |
Remove the rear wheel and tire.
Tightening torque:88.3
~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
|
|
| 2. |
Remove the rear wheel speed sensor
mounting bolt (A).
Tightening torque:7.8 ~
9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
|
|
| 3. |
Remove the rear seat back. (Refer
to the Body group - Seat) |
| 4. |
Disconnect the rear wheel speed
sensor connector. |
| 5. |
Installation is the reverse of
removal.
|
Install the rear sensor after lubricating the O-ring of sensor with
the assembly fluid(RAREMAX AF-1) When inserting the sensor, take
care the O-ring not to be damaged.
|
|
1.
Measure the output voltage between
the terminal of the wheel speed sensor and the body ground.
...
See also:
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace the airbag
module with a new one.
...
Installation
1.
Installation is the reverse of
removal.
After replacement or reinstallation procedure of the valve body assembly, ...
Inspection