Kia Optima: Removal
1. |
Disconnect the battery negative
cable and wait for at least three minutes before beginning work. |
2. |
Remove the glove box housing.
(Refer to the Body group- crash pad). |
3. |
Disconnect the passenger airbag
connector (A) and remove the PAB mounting bolts (B).
![](images/books/1353/stfrt1221n.gif)
|
4. |
Remove the crash pad. (Refer
to the Body group- crash pad).
If the PAB has been deployed, replace the damaged crash pad. |
|
5. |
Remove the heater duct from the
crash pad. |
6. |
Remove the mounting bolts from
the crash pad. And then remove the passenger airbag.
The removed airbag module should be stored in a clean, dry place
with the airbag cushion up. |
|
1.
Remove the ignition key from
the vehicle.
2.
Disconnect the battery negative
cable from battery and wait for at least three minutes before beginning
work.
...
See also:
Rear wheel alignment
When using a commercially available computerized wheel alignment equipment
to inspect the rear wheel alignment, always position the v ...
Automatic Transaxle Operation
The optional automatic transaxle is electronically controlled.
All normal forward driving is done with the shift lever in the D (Drive) position.
To move the shift lever from the P (Park) position ...
Air Bag Warning
This warning light will
remain on for approximately 6 seconds each time you turn the ignition switch ON.
If the system does not operate as described or if the light comes on while the vehicle
is ...