Kia Optima: Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pressure will need
to be adjusted after replacing the VFS solenoid valve. If replacing the
VFS solenoid valve; also replace the valve body assembly. (Refer to "Valve
Body" in this group) |
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
Description
Overdrive clutch control solenoid valve(OD/C_VFS) is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure inside
the overdrive clutc ...
See also:
Disassembly
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the front tire (A) from
hub assembly.
Tightening torque :
10~15N.m (9~11kgf.m, 7.37~11lbf.ft ...
Camshaft Position Sensor (CMPS). Schematic Diagrams
Circuit Diagram
...
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...