The rear parking assist system may not operate properly when:
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.)
2. The sensor is covered with foreign matter, such as snow
or water, or the sensor cover is blocked. (It will operate normally when the material
is removed or the sensor is no longer blocked.)
3. Driving on uneven road surfaces
(unpaved roads, gravel, bumps, gradient).
4. Objects generating excessive noise
(vehicle horns, loud motorcycle engines, or truck air brakes) are within range of
the sensor.
5. Heavy rain or water spray exists.
6. Wireless transmitters or
mobile phones are within range of the sensor.
7. The sensor is covered with snow.
8. Trailer towing
The detecting range may decrease when:
1. The sensor is stained with foreign matter such as snow or water. (The sensing
range will return to normal when removed.)
2. Outside air temperature is extremely
hot or cold.
The following objects may not be recognized by the sensor:
1. Sharp or slim objects such as ropes, chains or small poles.
2. Objects which
tend to absorb the sensor frequency such as clothes, spongy material or snow.
3. Undetectable objects smaller than 1 m (40 in.) in height and narrower than 14
cm (6 in.) in diameter.
Rear parking assist system precautions
✽ NOTICE
This system can only sense objects within the range and location of the sensors; It can not detect objects in other areas where sensors are not installed. Also, small or slim objects, such as poles or objects located between sensors may not be detected by the sensors.
Always visually check behind the vehicle when backing up.
Be sure to inform any drivers of the vehicle that may be unfamiliar with the system regarding the systems capabilities and limitations.
WARNING
Pay close attention when the vehicle is driven close to objects on the road, particularly pedestrians, and especially children. Be aware that some objects may not be detected by the sensors, due to the object’s distance, size or material, all of which can limit the effectiveness of the sensor. Always perform a visual inspection to make sure the vehicle is clear of all obstructions before moving the vehicle in any direction.
Components and Components Location
Components Location
1. Automatic transaxle
2. Valve body assembly
3. Oil pump assembly
...
Vanity mirror lamp
Push the switch to turn the light on or off.
: The lamp will turn on if this
button is pressed.
: The lamp will turn off if this
button is pressed.
CAUTION - Vanity mirror lamp (if equippe ...
Chart 1
...