Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures on this page. If in doubt, we strongly recommend that you have a competent technician or towing service jump start your vehicle.
✽ NOTICE
Use only a 12-volt jumper system. You can damage a 12-volt starting motor, ignition system, and other electrical parts beyond repair by use of a 24-volt power supply (either two 12-volt batteries in series or a 24- volt motor generator set).
WARNING - Battery
Never attempt to check the electrolyte level of the batey as this may cause the battery to rupture or explode causing serious injury.
WARNING - Battery
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
Outside rearview mirror
Be sure to adjust mirror angles before driving.
Your vehicle is equipped with both lefthand and right-hand outside rearview mirrors.
The mirrors can be adjusted remotely with the remote switch. The ...
Inspection
1.
Immerse the thermostat in water
and gradually heat the water.
2.
Check the valve opening temperature.
Valve opening temperature:
82 ± 1.5°C (17 ...