1. | Install the heater control unit. |
2. | Install the center fascia panel. |
3. | Install the crash pad garnish. |
Removal
1.
Disconnect the negative(-) battery
terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
Disconnect ...
Troubleshooting
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
...
Installation
Pressure Side Impact Sensor
1.
Install the new pressure side
impact sensor with the screws then connect the pressure side impact sensor
connector.
Tightening t ...