1. | Installation is the reverse of removal. |
2. | Perform the “Assembly check” with GDS. |
3. | Check that the brake operates normally by pushing the EPB switch more than 3 times after installing the EPB module. |
[CVVT System Mode]
(1) Low Speed / Low Load
(2) Part Load
(3) Low Speed / High Load
(4) High Speed / High Load
...
Push-starting
Your manual transaxle-equipped vehicle
should not be push-started because it
might damage the emission control system.
Vehicles equipped with automatic
transaxle cannot be push-started.
Follow ...
Installation
•
Install the component with the specified
torques.
•
Note that internal damag ...