Kia Optima: Installation
| 1. |
Remove ignition key from the
vehicle. |
| 2. |
Disconnect the negative (-) cable
from battery and wait for at least three minutes. |
| 3. |
Install the anchor pretensioner
with a bolt.
Tightening torque :39.2
~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
|
|
| 4. |
Connect the anchor pretensioner
connector. |
| 5. |
Install the center pillar trim.
(Refer to the Body group- Interior trim) |
| 6. |
Install the door scuff trim.
(Refer to the Body group- Interior trim) |
| 7. |
Insert the seat belt to the anchor
pretensioner (A).
|
Make sure the lock pin is connected in properly. |
|
| 8. |
Reconnect the battery negative
cable. |
| 9. |
After installing the anchor pretensioner,
confirm proper system operation:
| A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
1.
Disconnect the battery negative
cable, and wait for at least three minutes before beginning work.
2.
To remove the seat belt anchor
pretensioner (C), keep on push ...
See also:
Description
The SMART KEY system is a system that allows the user to access and operate a vehicle
in a very convenient way. To access the vehicle, no traditional key or remote control
unit is needed.The user ...
Electric WGT Control Actuator. Schematic Diagrams
Circuit Diagram
...
Limp home (override) procedure
When you turn the ignition switch to the ON position, if the immobilizer indicator
() goes off after blinking 5 times, your
transponder equipped in the ignition key is out of order. You cannot sta ...
Removal
Brake System