Kia Optima: Installation
| 1. |
Remove the ignition key from
the vehicle. |
| 2. |
Disconnect the battery negative
cable and wait for at least three minutes. |
| 3. |
Tighten the curtain airbag mounting
bolts and nuts.
Tightening torque:
Bolts: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Nuts: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.5 ~ 4.3 lb-ft)
|
| •
|
Never twist the
airbag module during installation. If the airbag module
is twisted, it may not operate as designed. |
|
|
| 4. |
Connect the curtain airbag connector. |
| 5. |
Install the roof trim. (Refer
to the Body group- Interior) |
| 6. |
Reconnect the battery negative
cable. |
| 7. |
After installing the curtain
airbag (CAB), confirm proper system operation:
| A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
1.
Disconnect the battery negative
cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim. (Refer
to the Body group- Interior)
...
Airbag Disposal
Special tool required
Deployment tool 0957A-34100ABefore scrapping any airbags or side airbags (including
those installed in vehicle to be scrapped), the airbags or si ...
See also:
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the ventilation hose (A) from the fuel
tank air filter. ...
Electrical System
1.
Be sure to disconnect the
battery cable from the negative (-) terminal of the battery.
2.
Never pull on the wires
when disconnecting connectors.
...
Interior light
CAUTION
Do not use the interior lights for extended periods when the engine is not running.
It may cause battery discharge.
WARNING
Do not use the interior lights when driving in the dark. Accid ...
Removal
Airbag Module Disposal. Description and Operation