Kia Optima: Installation
| 1. |
Remove the ignition key from
the vehicle. |
| 2. |
Disconnect the battery negative
cable and wait for at least three minutes before beginning work. |
| 3. |
Install the SRSCM with the SRSCM
mounting nuts.
Tightening torque:7.0 ~
9.0 N.m (0.7 ~ 0.9 kgf.m, 5.2 ~ 6.7 lb-ft)
|
|
Use new mounting bolts when replacing the SRSCM after a collision.
When installing the SRSCM bolt, install the ground wire (B) with
a bolt as indicated above picture.
|
|
| 4. |
Connect the SRSCM harness connector. |
| 5. |
Install the floor console. (Refer
to the Body group - console) |
| 6. |
Reconnect the battery negative
cable. |
| 7. |
After installing the SRSCM, confirm
proper system operation:
| A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
1.
Remove the ignition key from
the vehicle.
2.
Disconnect the battery negative
cable and wait for at least three minutes before beginning work.
3.
Re ...
After replacing the SRSCM with a new one, the “Variant Coding” procedure must be
performed.
1.
On SRSCM variant codi ...
See also:
Teaching Procedures
1.
Key Teaching ProcedureKey
teaching must be done after replacing a defective PCM(ECM) or when providing
additional keys to the vehicle owner.
The procedure starts with an PC ...
Oil And Filter Replacement
•
Prolonged and repeated
contact with mineral oil will result in the removal of natural fats
from the skin ...
Inspection
1.
Check the hub for cracks and
the splines for wear.
2.
Check the brake disc for scoring
and damage.
3.
Check the knuckle for cracks
4. ...
Removal
Variant coding