Kia Optima: Installation
| 1. |
Installation is the reverse of
removal. |
|
After replacement or reinstallation procedure of the valve body assembly,
must perform procedures below. |
| • |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
| • |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
| • |
Perform TCM learning
after replacing the valve body to prevent slow transaxle response,
jerky acceleration and jerky startup. (Refer to "Automatic transaxle
control system (Repair procedures)" in this group) |
|
1.
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:7.8 ~
11 ...
See also:
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
:4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove th ...
Radial-ply tires
Radial-ply tires provide improved
tread life, road hazard resistance and
smoother high speed ride. The radial-
ply tires used on this vehicle are of
belted construction, and are selected
to ...
Driving in Flooded Areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
Removal
Clutch & Brake