Kia Optima: Inspection - Intake Actuator. Repair procedures - Blower - Heating,Ventilation, Air Conditioning - Kia Optima TF 2011-2023 Service ManualKia Optima: Inspection

1. Ignition "OFF".
2. Disconnect the intake actuator connector.
3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grounding terminal 7.
4. Verify that the intake actuator operates to the fresh position when connecting in the reverse.

1. -                 
2. –                  
3. Fresh              
4. 5V (Vcc)
5. Feedback Signal
6. Sensor Ground
7. Recirculation

5. If the intake actuator is not operated well, substitute with a known-good intake actuator and check for proper operation.
6. If the problem is corrected, replace the intake actuator.

Intake Actuator. Repair procedures
...

Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad.(Refer to BD group - "Crash Pad") 3. Disconnect the Intake actu ...

See also:

Engine compartment
2.4L Engine 2.0L Engine * The actual engine room in the vehicle may differ from the illustration. 1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake/clutch fluid reservoir ...

Components and Components Location
Components 1. HECU module 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Yaw rate & Lateral G sensor 5. Steering angle sensor 6. ABS Warning lamp ...

Installation
Brake Booster 1. Installation is the reverse of removal. • Before ins ...

Copyright © www.kiopman.com 2023