1. | Measure the pressure of high
pressure line by measuring voltage output between NO.1 and NO.2 terminals.
|
2. | Inspect the voltage value whether
it is sufficient to be regular value or not.
|
3. | If the measured voltage value is not specification, replace the A/C pressure transducer. |
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the
"ON" position.
2.
Cover the front sensor to stop
...
Removal
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the driver crash pad lower
panel.(Refer to the BD group - "Crash pad")
3.
Rem ...
Front Impact Sensor (FIS). Description and Operation
Description
The front impact sensor (FIS) is installed in the Front End Module (FEM). They are
remote sensors that detect acceleration due to a collision at its mounting location.
The primary pur ...