Kia Optima: Inspection
| 1. |
Check the bushing for wear. |
| 2. |
Check the brake pedal for bending
or twisting. |
| 3. |
Check the brake pedal return
spring for damage. |
| 4. |
Check the stop lamp switch.
| (1) |
Connect a circuit tester
to the connector of stop lamp switch, and check whether or not there
is continuity when the plunger of the stop lamp switch is pushed
in and when it is released. |
| (2) |
The stop lamp switch
is in good condition if there is no continuity when plunger(A) is
pushed.
|
|
1.
Turn ignition switch OFF and
disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel
and reinforcing panel. (Refer to the Body group- crash ...
Stop lamp switch clearance adjustment
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in),
conform to below.
1.
Disconnect the stop lamp switch
...
See also:
Input Speed Sensor. Description and Operation
Description
Input speed sensor is a vital unit that measures the rate of rotation of the input
shaft inside the transaxle and delivers the readings to the TCM. The sensor provides
critical input ...
Components and Components Location
Component Location
1. Hood switch
2. Burglar horn
3. BCM and RF antenna
4. Key warning switch
5. Front door switch
6. Front door lock actuator & switch
...
Customer Complaint Analysis Check Sheet
There are several areas where a problem can occur: wiring harness, the radio, the
CD player, and speaker. Troubleshooting enables you to confine the problem to a
particular area.
...
Removal
Adjustment