Kia Optima: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the oil temperature
sensor connector. |
| 3. |
Measure resistance between sensor
signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is
within the specification. |
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
See also:
Lift And Support Points
When heavy rear components such as suspension, fuel tank, spare tire,
tailgate and trunk lid are to be removed, place additional weig ...
Installation
1.
Installation is the reverse of
removal.
2.
Use a SST (09581-11000) when
installing the brake caliper assembly.
3.
After installation, bleed ...
Antenna. Repair procedures
Inspection
Glass Antenna Test
1.
Wrap aluminum foil (A) around
the tip of the tester probe (B) as shown.
2.
Touch one tester probe to the
glass antenna termin ...