Kia Optima: Inspection - Line Pressure Control Solenoid Vale. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Optima TF 2011-2023 Service ManualKia Optima: Inspection

1. Turn ignition switch OFF.
2. Disconnect the oil temperature sensor connector.
3. Measure resistance between sensor signal terminal and sensor ground terminal.
4. Check that the resistance is within the specification.

Line Pressure Control Solenoid Vale. Repair procedures
...

Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pre ...

See also:

Removal
1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 2. Remove the fuel pump service cover (A) in the ...

Rear Door. Components and Components Location
Components 1. Rear door trim 2. Rear door belt inside weatherstrip 3. Rear door trim seal 4. Rear door module 5. Rear door panel 6. Rear door side molding 7. Rear do ...

Output Speed Sensor. Description and Operation
Description The output speed sensor is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the TCM. The sensor prov ...

Copyright © www.kiopman.com 2023