Kia Optima: Immobilizer Control Unit. Repair procedures
Replacement
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") |
| 3. | Disconnect the 5P connector of
the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the
bolt. [USA]
|
| 4. | Disconnect the immobilizer unit
connector and then remove the immobilizer unit(A) and bracket after loosening
a shear bolt or removing the unit from the mounting bracket (B) using a
flat-up screwdriver.
|
| 5. | Installation is the reverse of removal procedure. |
Replacement
Problems And Replacement Parts:
Problem
Part set
GDS required?
All keys have been lost
Blank key (4)
YES
Antenna ...
Antenna Coil. Repair procedures
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the steering column upper
and lower shrouds after loosening the screws (3EA).
...
See also:
Lubricants
Engine
Joint
Lubricants
Quantity
Gasoline 2.0 T-GDI (AT)
BJ
GRB006
145g±10g
TJ
...
If engine turns over normally but
does not start
1. Check fuel level.
2. With the ignition switch in the LOCK
position, check all connectors at the
ignition coil and spark plugs.
Reconnect any that may be disconnected
or loose.
3. Check th ...
Troubleshooting
Failure Diagnosis
1.
In principle, ESC and TCS controls
are prohibited in case of ABS failure.
2.
When ESC or TCS fails, only the
failed system control is prohibited ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright � www.kiopman.com 2026