Troubleshooting
Trouble Symptom |
Probable cause |
Remedy |
Vehicle pulls to one side |
Scoring of driveshaft ball joint |
Replace |
Wear, rattle or scoring of wheel bearing |
Replace |
|
Defective front suspension and steering |
Adjustment or Replace |
|
Vibration |
Wear, damage or bending of driveshaft |
Replace |
Driveshaft rattle and hub serration |
Replace |
|
Wear, rattle or scratching of wheel bearing |
Replace |
|
Shimmy |
Defective wheel balance |
Adjustment or Replace |
Defective front suspension and steering |
Adjustment or Replace |
|
Excessive noise |
Wear, damage or bending of driveshaft |
Replace |
Rattle of driveshaft and worn hub splines |
Replace |
|
Wear, rattle or scoring of wheel bearing |
Replace |
|
Loose hub nut |
Adjustment or Replace |
|
Defective front suspension and steering |
Adjustment or Replace |
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet
its seal with engine coolant, and then install it on a pressure tester.
2.
Apply a pressure of 93.16 ~ 122.58k ...
Towing
If emergency towing is necessary, we recommend having it done by an authorized
Kia dealer or a commercial tow-truck service. Proper lifting and towing procedures
are necessary to prevent damage to ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is found, repa ...