Kia Optima: Specifications - Multifunction switch - Body Electrical System - Kia Optima TF 2011-2021 Service ManualKia Optima: Specifications

Specifications

Items
Specifications
Rated voltage
DC 12V
Operating temperature range
-30°C ~ +80°C (-22 ~ +176°F)
Rated load
Dimmer & passing switch
High : 0.2A (Relay load)
Low : 0.2A (Relay load)
Passing : 0.2A (Relay load)
Lighting switch
Lighting : 0.2A (Relay load)
Turn signal & lane change switch
6.6 ± 0.5A (Lamp load)
Fog lamp switch
0.2A (Relay load)
Wiper & mist switch
Low, High : 4.5A (Motor load)
Intermittent : 0.22 ± 0.05A (Relay load)
Lock : Max. 28A (Motor load)
Mist : 4.0A (Motor load)
Washer switch
4A (Motor load)


Multifunction switch
...

Components and Components Location
Component(1) Component(2) <Installation order : A→B→C→D→E> 1. Steering column shaft 2. Lighting switch 3. Wiper and washer switch 4. ...

See also:

Temperature Control Knob
The temperature control knob is the round knob closest to the passenger side of the ventilation control panel. To change the air temperature in the passenger compartment, turn the knob either cloc ...

Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when: 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with forei ...

Evaporator Temperature Sensor Repair procedures
Inspection 1. Ignition "OFF" 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Spec ...

Copyright © www.kiopman.com 2021