1. | Disconnect the negative (-) battery terminal. |
2. | Remove the crash pad. (Refer to BD group - "Crash Pad") |
3. | Disconnect the Intake actuator connector (A) |
4. | Loosen the mounting screw and
then remove the intake actuator (B).
|
5. | Installation is the reverse order of removal. |
Trailing Arm. Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque:88.3
~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
General Service Information
Protection Of The VehicleAlways
be sure to cover fenders, seats, and floor areas before starting work.
The support rod must be inserte ...
Installation
1.
Installation is the reverse of
removal.
•
If you don't
...