1. | Disconnect the negative (-) battery terminal. |
2. | Remove the head lamp assembly. (Refer to the head lamp) |
3. | Remove the head lamp leveling
actuator (A) by loosening the adjusting bolt (B) after rotating it to an
arrow direction.
|
4. | Installation is the reverse of removal procedure. |
Checking Cables And Wires
1.
Check the terminal for
tightness.
2.
Check terminals and wires
for corrosion from battery electrolyte, etc.
3.
Check terminals and wire ...
Removal
1.
Remove the rear wheel & tire.
Tightening torque:88.3
~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Inspection
1.
Check the audio remote control
switch for resistance between terminals in each switch position.[Trip
+ Reset]
Switch
Connector
...