Kia Optima: Remove - Electronic Parking Brake (EPB). Repair procedures - Parking Brake System - Brake System - Kia Optima TF 2011-2026 Service ManualKia Optima: Remove

1. Turn ignition OFF and disconnect the negative (-) battery cable.
2. Remove the crash pad lower panel.

(Refer to Body – “Crash pad”)

3. Disconnect the EPB control unit connector.

4. EPB control unit mounting nuts (B) and then remove EPB control unit.

Tighten torque:

7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)



Electronic Parking Brake (EPB). Repair procedures
...

Installation
1. Installation is the reverse of removal. 2. Perform the “Assembly check” with GDS. 3. Check that the brake operates normally by pushing the ...

See also:

Air Ventilation Seat. Schematic Diagrams
Circuit Diagram ...

Emergency trunk lid release cable
1.Take the cover out by putting the driver or key at left side. 2.Pull the hook of cable. 3. After use, securely close the cover. CAUTION While driving the vehicle, Don’t use it. Unexpecte ...

VSM (Vehicle stability management)
This system provides further enhancements to vehicle stability and steering responses when a vehicle is driving on a slippery road or a vehicle detected changes in coefficient of friction between ...

Copyright www.kiopman.com 2026