Kia Optima: Removal
|
| 1. | Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Disconnect the ECM Connector (A).
|
| 3. | Remove the air cleaner assembly (Refer to "Intake And Exhaust System" in EM group). |
| 4. |
Remove the mounting bolts (A) and nut (B), and then
remove the ECM assembly (C).
|
| 5. |
Remove the installation nuts (A) and screw (B), and
then remove the ECM (C) from the bracket.
|
Installation
In the case of the vehicle equipped with immobilizer
or button engine start system, perform "Key Teaching" procedure together
...
See also:
Disassembly
1.
Remove the snap ring (A).
2.
Remove the hub assembly from
the knuckle assembly.
(1)
Install the front knuckle
assembly (A) on press.
...
Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when:
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.) 2. The sensor is covered with forei ...
Aluminum Wheel Maintenance
The aluminum wheels are coated with a clear protective finish.
Do not use any abrasive cleaner, polishing compound, solvent, or wire brushes
on aluminum wheels. They may scratch or damage the f ...
Copyright © www.kiopman.com 2024