Kia Optima: Removal - Auto Light Sensor. Repair procedures - Auto Lighting Control System - Body Electrical System - Kia Optima TF 2011-2026 Service ManualKia Optima: Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver.

Apply the protective tapes to auto light sensor and its related parts.
3. Remove the auto light connector.

Inspection
In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's i ...

Installation
1. Reconnect the auto light connector. 2. Install the auto light sensor. ...

See also:

Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine ...

Yaw-rate and Lateral G Sensor. Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electronically by the vibration change of plate fork inside the yaw rate sensor.If ...

Trouble Diagnostics When Using GDS
1. The body control module can diagnose by using the GDS more quickly.The BCM communicates with the GDS and then reads the input/output value and drives the actuator. ...

Copyright www.kiopman.com 2026