Kia Optima: Installation - Auto Light Sensor. Repair procedures - Auto Lighting Control System - Body Electrical System - Kia Optima TF 2011-2020 Service ManualKia Optima: Installation

1. Reconnect the auto light connector.
2. Install the auto light sensor.

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver. ...

Auto Head Lamp Leveling Device
...

See also:

Operation of the rear parking assist system
Operating condition This system will activate when backing up with the ignition switch ON. The sensing distance while the rear parking assist system is in operation is approximately 120 cm (4 ...

Automatic Operation
The FATC (Full Automatic Temperature Control) system automatically controls the heating and cooling by doing as follows: 1. Push the "AUTO" switch. The indicator light will come on confir ...

Inspection
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. ...

Copyright © www.kiopman.com 2020