Kia Optima: Removal - Hazard Lamp Switch. Repair procedures - Lighting System - Body Electrical System - Kia Optima TF 2011-2020 Service ManualKia Optima: Removal

1. Disconnect the negative(-) battery terminal.
2. Remove the heater comtral module.

(Refer to the HA group - "Controller")


Inspection
1. It will be able to diagnose defects of hazard switch with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosis. 2. S ...

Installation
1. Install the heater control module. ...

See also:

Installation
1. Install the power window switch module. 2. Install the door trim panel after reconnecting the relevant connectors ...

Headlight High Beam Indicator
This indicator illuminates when the headlights are on and in the high beam position or when the turn signal lever is pulled into the Flash-to-Pass position. ...

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to ...

Copyright © www.kiopman.com 2020