Kia Optima: Removal
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the seat control switch
(A).
|
| 3. | Remove the seat side cover (A). (Refer to the BD group - "Front seat")
|
| 4. | Disconnect the power seat control
switch connector (A).
|
| 5. | Remove the power seat control
switch (A) after removing the mounting screws (3EA).
|
Inspection
With the power seat switch in each position, make sure that continuity exists between
the terminals below. If continuity is not as specified, replace the power seat switch.
A : Power seat control s ...
Installation
-
Make sure that the IMS
control switch connectors and related connectors are plugged in
properly.
...
See also:
Wheel alignment and tire balance
The wheels on your vehicle were
aligned and balanced carefully at the
factory to give you the longest tire life
and best overall performance.
In most cases, you will not need to
have your whe ...
Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure
resistance between TCM and chassis ground using the backside of TCM harness
connector as TCM side check point. If ...
Trunk room lamp
The trunk room lamp comes on when the trunk is opened.
CAUTION
The trunk room lamp comes on as long as the trunk lid opens. To prevent unnecessary
charging system drain, close the trunk lid sec ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026