1. | Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Disconnect the accelerator position sensor connector
(A). |
3. |
Remove the installation nuts (B) and bolt (C), and
then remove the accelerator pedal module.
|
HAC (Hill-start assist control)
Hill start Assist Control is a comfort function. The main intend is to prevent
the vehicle from rolling backwards while driving off uphill on an inclined surface.
HAC holds the braking pressure bu ...
Rear Bumper Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Put on gloves to protect your ...
Emission control system
The emission control system of your
vehicle is covered by a written limited
warranty. Please see the warranty information
contained in the Warranty &
Maintenance booklet in your vehicle.
...