Kia Optima: Removal
| 1. | Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. | Disconnect the purge control solenoid valve connector (A). |
| 3. |
Disconnect the vapor hoses (B) from the purge control
solenoid valve.
|
| 4. |
Remove the valve from the bracket in the direction
of the arrow.
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and
2.
4.
...
Installation
•
Install the component with the specified
torques.
•
Note that internal d ...
See also:
Cowl Top Cover. Repair procedures
Replacement
1.
Remove the cap (B) and remove
the nuts, then remove the wiper arm (A).
Tightening torque :22.6~26.5
N.m(2.3~2.7 kgf.m, 16.6~19.5 lb-ft)
...
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection ProcedureMeasuring Condition of Electronic Parts' Resistance
The measured resistance at hi ...
Repair
procedures
Starter Circuit Troubleshooting
The battery must be in good condition and fully charged.
1.
Disconnect the fuel ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026