Kia Optima: Removal
| 1. | Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Remove the fuel pump service cover (A) in the trunk.
|
| 3. |
Disconnect the fuel tank pressure sensor connector
(A), and then remove the fuel tank pressure sensor.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
Refer to "Specification"
...
Installation
•
Install the component with the specified
torques.
•
Note that internal d ...
See also:
Maintenance Services
You should exercise the utmost care to prevent both damage to your vehicle and
injury to yourself whenever performing any maintenance or inspection procedures.
Should you have any doubts concerning ...
Inspection
1.
Check the audio remote control
switch for resistance between terminals in each switch position.[Trip
+ Reset]
Switch
Connector
...
Valve Body. Components and Components Location
Components Location
1. PCV adjust screw
2. Solenoid valve
3. Oil temperature sensor
4. Accumulator
5. Low & reverse brake(LR/B) pressure flow hole
6. Under ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026