Kia Optima: Rear Axle Assembly - Driveshaft and axle - Kia Optima TF 2011-2020 Service ManualKia Optima: Rear Axle Assembly

Reassembly
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots. 2. Apply grease to the joint boot on the side of the wheel and install the boot. ...

Rear Hub - Carrier. Components and Components Location
Components 1. Rear carrier assembly 2. Parking brake assembly 3. Rear hub assembly 4. Rear brake disc ...

See also:

Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the lower (A) after loosening the mounting screws.(Refer to the BD group - "Crash pad") ...

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between sensor signal terminal and sensor g ...

Blower Unit. Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad and heater blower unit.(Refer to HA group-heater unit) 3. Re ...

Copyright © www.kiopman.com 2020