Kia Optima: Rail Pressure Sensor (RPS). Repair procedures

Rail Pressure Sensor (RPS). Schematic Diagrams

Circuit Diagram ...

Inspection

1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Condition ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the EWGA connector (A). 3. Remove the shaft ...

Key matrix
...

Inspection
Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor input s ...