Kia Optima: Measuring Body Dimensions - General Information - Kia Optima TF 2011-2019 Service ManualKia Optima: Measuring Body Dimensions

1. Basically, all measurements in this manual are taken with a tracking gauge.
2. When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3. For measuring dimensions, both projected dimensions and actual - measurement dimensions are used in this manual.
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or tubing. ...

Dimensions Projected
1. These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body alterations ...

See also:

To resume cruising speed at more than approximately 40 km/h (25 mph)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...

Manual Antenna
Your car uses a manual stainless steel antenna to receive both AM and FM broadcast signals. Pull up the antenna using your fingers, as shown in the drawing. ✽ NOTICE Before entering an au ...

Camshaft Position Sensor (CMPS). Description and Operation
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element.It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

Copyright © www.kiopman.com 2019