Kia Optima: Installation - Canister. Repair procedures - Evaporative Emission Control 
		System - Emission Control System - Kia Optima TF 2011-2019 Service ManualKia Optima: Installation

Installation is the reverse of removal.


Canister installation bolt:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)



Inspection
1. Check for the following items visually. A. Cracks or leakage of the canister B. Loose connection, distortion, or damage of ...

Fuel Filler Cap. Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and t ...

See also:

Receiver-Drier. Repair procedures
Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque :20~25N.m (2.0~2.5kgf.m, 14.5~18.2lb-ft) ...

In the Event of Brake Failure
If the service brakes should fail to operate while the vehicle is in motion, you can make an emergency stop with the parking brake. The stopping distance, however, will be much greater than normal ...

Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

Copyright © www.kiopman.com 2019