Kia Optima: Installation - Seat Belt Buckle Switch (BS). Repair procedures - SRSCM - Restraint - Kia Optima TF 2011-2026 Service ManualKia Optima: Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.
1. Remove the ignition key from the vehicle.
2. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3. Install the seat belt buckle switch.

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)


4. Install the front seat assembly. . (Refer to the Body group- Front seat)
5. Reconnect the battery negative cable.
6. After installing the seat belt buckle switch, confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.

Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Refer to the Body group- Fron ...

Weight Classification System (WCS). Description and Operation
Description In contrast to the initial one-stage airbag systems, newer restraint systems involve complex logic to select, or alternatively suppress, various levels of safety system deployment. In ...

See also:

Snow Tires
If you mount snow tires on your Kia, make sure they are radial tires of the same size and load range as the original tires. Mount snow tires on all four wheels to balance your vehicle’s handling ...

Rear Seat Armrest
This armrest is located in the center of the rear seatback. Pull the armrest down using the strap provided on the armrest. To open the armrest cover, press the button on the top of the cover and ...

Components (With EPB)
1. Guide rod bolt 2. Bleed screw 3. Caliper carrier 4. Caliper body 5. Brake pad 6. Pad retainer ...

Copyright www.kiopman.com 2026