Kia Optima: Installation
| 1. |
Installation is the reverse of
removal. |
After replacement or reinstallation procedure of the valve body assembly,
must perform procedures below.
| • |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
| • |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
|
1.
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:7.8 ~
11 ...
Description
Input speed sensor is a vital unit that measures the rate of rotation of the input
shaft inside the transaxle and delivers the readings to the TCM. The sensor provides
critical input ...
See also:
Cup Holder
The cup holder can be opened by pressing. The cover will slowly open.
WARNING - Hot Liquids
Do not place uncovered cups of hot liquid in the cup holder while the vehicle
is in motion. I ...
Troubleshooting
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
...
Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when:
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.) 2. The sensor is covered with forei ...
Removal
Input Speed Sensor. Description and Operation