Kia Optima: Installation - Transaxle Control Module (TCM). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Optima TF 2011-2020 Service ManualKia Optima: Installation

1. Installation is reverse of removal.
In the case of the vehicle equipped with immobilizer or button engine start system, perform "Key Teaching" procedure together (Refer to "Immobilizer" or "Button Engine Start System in BE group).

Replacement
1. Turn ignition switch OFF. 2. Disconnect the negative (-) battery cable. 3. Disconnect the TCM connector (A). 4. Re ...

Transaxle Oil Temperature Sensor. Description and Operation
Description Transaxle oil temperature sensor monitors the automatic transaxle fluid's temperature and conveys the readings to TCM. It is an NTC (Negative Thermal Coefficient) sensor whose res ...

See also:

Defogging logic
To reduce the probability of fogging up inside of the windshield, the air intake or air conditioning are controlled automatically according to certain conditions such as or position. To cancel ...

Knock Sensor (KS). Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin ...

Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully the first time ...

Copyright © www.kiopman.com 2020