Kia Optima: Inspection - Panoramaroof Motor. Repair procedures - Panoramaroof - Body Electrical System - Kia Optima TF 2011-2026 Service ManualKia Optima: Inspection

1. Disconnect the negative (-) battery terminal.
2. Remove the roof trim.

(Refer to the BD group - "Roof trim")

3. Disconnect the panoramaroof motor (A) connector.

4. Ground the terminals as below table, and check that the panoramaroof unit operates.
- When inspecting the panoramaroof motor operation, panoramaroof motor and roller blind motor always should be connected.

5. Make these input tests at the connector. If any test indicates a problem, find and correct the cause, then recheck the system. If all the input tests prove OK, the panoramaroof motor must be faulty; replace it.
Terminal
Test
condition
Test: Desired result
3
IG2 ON
Check for voltage to ground:
There should be battery voltage.
1
Under all
conditions
Check for continuity to ground:
There should be continuity.
6
Under all
conditions
Check for voltage to ground:
There should be battery voltage.

6. Ground the terminals as below table, and check that the roller blind motor operates.


Panoramaroof Motor. Repair procedures
...

Resetting The Panoramaroof
Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the panoramaroof, you have to reset your panoramaroof system as follows : 1. Turn th ...

See also:

Inspection
Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cover the front sensor to stop ...

Installation
1. Install the key lock cylinder. 2. Install the key warning switch and key Illumination. 3. Install the key warning/immobilizer connector. ...

Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be he ...

Copyright www.kiopman.com 2026