Kia Optima: Inspection
| 1. | Turn ignition switch OFF. |
| 2. | Disconnect the oil temperature sensor connector. |
| 3. | Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. | Check that the resistance is within the specification. |
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
See also:
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is found, repa ...
Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure
resistance between TCM and chassis ground using the backside of TCM harness
connector as TCM side check point. If ...
Engine Exhaust Gas Precautions
WARNING
Engine exhaust gases contain carbon monoxide (CO). Though colorless and odorless,
it is dangerous and could be lethal if inhaled. Follow the instructions below to
avoid CO poisoning. ...
Copyright © www.kiopman.com 2020