Kia Optima: General Service Information - General Information - Kia Optima TF 2011-2019 Service ManualKia Optima: General Service Information

Protection Of The Vehicle

Always be sure to cover fenders, seats, and floor areas before starting work.

The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the hood from falling and causing possible injury.

Make sure that the support rod has been released prior to closing the hood. Always check to be sure the hood is firmly latched before driving the vehicle.

Meaning Of Symbols
There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. Symbol Meaning ...

Preparation Of Tools And Measuring Equipment
Be sure that all necessary tools and measuring equipment are available starting work. ...

See also:

Output Speed Sensor. Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speedFig 2) Input/Output speed sensor at high speed ...

Electrical Equipment
The electrical system of your vehicle is designed to perform under all reasonably expected operating conditions. However, before any additional electrical equipment is installed in your vehicle, c ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV terminals 1 and 2. 4. ...

Copyright © www.kiopman.com 2019