Remove
1. | Turn ignition OFF and disconnect the negative (-) battery cable. |
2. | Remove the floor console upper
cover. (Refer to Body group - "Console") |
3. | Remove the EPB switch assembly
after loosening the screws.
|
4. | Installation is the reverse of removal. |
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Output Speed Sensor Troubleshooting
Signal Waveform
...
Description
Network ConfigurationThe Network of the SJB(Smart Junction Box) consists of Low
speed CAN as shown in the following figure.
Termination ResistorThe cluster has CAN termination resistor. It is p ...