Kia Optima: Description and Operation
Description
Tread Lamp
| - |
Tire Under Inflation / Leak Warning.
|
| 1. |
Turn on condition
| A. |
When tire pressure is
below allowed threshold |
|
| 2. |
Turn off condition
| A. |
When tire pressure is
above(warning threshold + hysteresis). |
| B. |
When tire pressure leakage
is less than 3 psi per min. |
|
DTC Warning
| 1. |
Turn on condition
| A. |
When the system detects
a fault that is external to the receiver / initator / sensor. |
| B. |
When the system detects
a receiver fault. |
| C. |
When the system detects
a sensor fault. |
|
System Fault
| 1. |
General Function
| A. |
The system monitors a
number of inputs across time in order to determine that a fault
exists. |
| B. |
Faults are prioritized
according to which has the most likely cause. |
| C. |
Certain faults are not
covered through DTC. The main ones are: |
| 1) |
Receiver Micro-controller
lock up ; requires observation of lamps at Ignition ON to
diagnose. |
| 2) |
Ignition Line
stuck ; requires observation of lamps at Ignition ON to
diagnose. |
|
|
Components Location
1. Receiver
2. TPMS sensor (FL)
3. TPMS sensor (RL)
4. TPMS sensor (RR)
5. TPMS sensor (FR)
...
Description
1.
Mode
(1)
Configuration State
A.
All sensors should
be in the Low Line state.
B.
In Low ...
See also:
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is
blown, you must reset your sunroof system as follows:
1.Turn the ignition switch to the ON position and close the sunr ...
Rear seatback lock
When the rear seatback lock lever (located on the backside of the rear seatback)
is in the “LOCK” position, it is not possible to fold the rear seatback down by
using the release lock lever. ...
Inspection
With the power seat switch in each position, make sure that continuity exists between
the terminals below. If continuity is not as specified, replace the power seat switch.
A : Power seat control s ...
Components and Components Location
TPMS Sensor. Description and Operation