Kia Optima: Blower Unit. Repair procedures - Blower - Heating,Ventilation, Air Conditioning - Kia Optima TF 2011-2019 Service ManualKia Optima: Blower Unit. Repair procedures

Replacement

1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad and heater blower unit.

(Refer to HA group-heater unit)

3. Remove the heater blower unit from crash pad. (Refer to HA group - "Heater Unit")
4. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and screws.

Make sure that there is no air leaking out of the blower and duct joints.
5. Installation is the reverse order of removal.

Components
1. Duct Seal 2. Duct Case 3. Inlet Door 4. Intake Actuator 5. Inlet Duct Case (A) 6. Climate Control Air Filter 7. Cluster Ionizer 8. Climate Control Air Fi ...

Blower Motor. Repair procedures
...

See also:

Repair procedures
Refrigerant System Service Basics Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air ...

Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and ...

Radiator. Components and Components Location
Components   1. Cooling fan assembly 2. Radiator 3. Mounting insulator 4. Radiator mounting bracket 5. Radiator upper hose 6. Radiator lower hose 7. Res ...

Copyright © www.kiopman.com 2019