1. | Disconnect the negative (-) battery terminal. |
2. | Remove the driver airbag module. (Refer to the RT group) |
3. | Remove the steering wheel. (Refer to the ST group - "Steering column & shaft") |
4. | Remove the steering wheel cover
(A) after loosening the screws.
|
5. | Remove the steering wheel remote
control switch connector (A) after loosening the mounting screws.
|
Description
Network ConfigurationThe Network of the SJB(Smart Junction Box) consists of Low
speed CAN as shown in the following figure.
Termination ResistorThe cluster has CAN termination resistor. It is p ...
Removal
Parking Brake Pedal [Foot type]
1.
Turn ignition OFF and disconnect
the negative (-) battery cable.
2.
Remove the crash pad lower panel
and reinforcing panel. (Refer t ...
Specification
Engine
T/M
Joint type
Max. permissible angle
Outer
Inner
Outer
Inner
Gasoline 2.0 T-GDI
...