Kia Optima: Removal

Inspection

1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T ...

Installation

Refer to "Accelerator Pedal" in this group. ...

See also:

Inspection
1. Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. 2. Check t ...

Adjustment
Adjusting method for T/M control cable 1. Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" pos ...

Installation
1. Make sure of the length of compressor mounting bolts, and then tighten it A→B→C→D order. Tightening torque :20.0~32.9N.m (2.04~3.36kgf.m, 14.7~24 ...