Kia Optima: Power Window Motor. Repair procedures
Inspection
Front Power Window Motor Inspection| 1. | Remove the front door trim panel. (Refer to the BD group - "Front door") |
| 2. | Disconnect the connector from
the motor.
|
| 3. | Connect the motor terminals No.2
and No.3 directly to battery voltage (12V) and check that the motor operates
smoothly. If the operation is abnormal, replace the motor. [Safety Power Window]
|
| 4. | Connect the motor terminals directly
to battery voltage (12V) and check that the motor operates smoothly. Next,
reverse the polarity and check that the motor operates smoothly in the reverse
direction. If the operation is abnormal, replace the motor.
|
| 1. | Remove the rear door trim panel. (Refer to the BD group - "Rear door") |
| 2. | Disconnect the 2P connector from
the motor.
|
| 3. | Connect the motor terminals directly
to battery voltage (12V) and check that the motor operates smoothly. Next,
reverse the polarity and check that the motor operates smoothly in the reverse
direction. If the operation is abnormal, replace the motor.
|
Power Window Motor. Schematic Diagrams
Circuit Diagram
...
See also:
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
Refer to "Specification"
...
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace the airbag
module with a new one.
...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
