Kia Optima: Installation
Installation is in the reverse order of removal.
Perform the following :
| • |
Refill engine with engine oil. |
| • |
Refill a transaxle with fluid. |
| • |
Refill a radiator and a reservoir
tank with engine coolant. |
| • |
Clean battery posts and cable
terminals and assemble. |
| • |
Inspect for fuel leakage.
|
| - |
After assemble the fuel line,
turn on the ignition switch (do not operate the starter) so that the fuel
pump runs for approximately two seconds and fuel line pressurizes. |
| - |
Repeat this operation two or
three times, then check for fuel leakage at any point in the fuel line. |
| • |
Bleed air from the cooling system. |
| - |
Start engine and let it run until
it warms up. (until the radiator fan operates 3 or 4 times.) |
| - |
Turn Off the engine. Check the
level in the radiator, add coolant if needed. This will allow trapped air
to be removed from the cooling system. |
| - |
Put radiator cap on tightly,
then run the engine again and check for leaks. |
•
Use fender covers to
avoid damaging painted surfaces.
•
To avoid damage, unplu ...
See also:
Front Seat Adjustment - Power
The driver's seat can be adjusted by using the control knob on the left side
of the seat. Before driving, adjust the seat to the proper position so as to easily
control the steering wheel, ped ...
Toll Free Assistance
Kia’s toll-free hot line is staffed 24 hours a day, 365 days a year, and is accessible
from anywhere in the U.S. or Canada by dialing 1-800-333-4Kia. ...
Components
1. Heater Case (LH)
2. Separator
3. Evaporator Core
4. Shower Duct
5. Heater Core Cover
6. Heater Core
7. Mode Actuator
8. Mode Cam
9. Temp Actua ...
Removal
Timing System