Kia Optima: Installation
| 1. |
Installation is the reverse of
removal. |
After replacement or reinstallation procedure of the valve body assembly,
must perform procedures below.
| • |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
| • |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
|
1.
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:7.8 ~
11 ...
Description
The output speed sensor is a vital unit that measures the rate of rotation of the
transaxle's turbine shaft and output shaft, and delivers the readings to the TCM.
The sensor prov ...
See also:
Components
1. Duct Seal
2. Duct Case
3. Inlet Door
4. Intake Actuator
5. Inlet Duct Case (A)
6. Climate Control Air Filter
7. Cluster Ionizer
8. Climate Control Air Fi ...
Replacement
1.
Remove the rear wheel & tire.
Tightening torque:88.3
~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Removal
1.
Disconnect the battery negative
cable, and wait for at least three minutes before beginning work.
2.
Remove the front passenger seat
assembly.(Refer to the Body gr ...
Removal
Output Speed Sensor. Description and Operation