Kia Optima: Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.
HL : Head lamp low beam
P : Head lamp passing switchTurn Signal Switch
With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.
Inspection (With GDS)
1.
Check BCM input/output specification
of multifunction switch using the GDS. If the specification is abnormal,
replace the lamp or wiper switch.
2.
If diagnosis is ...
See also:
Adjusting the Front Seatback Recliner
To change the seatback angle, lean forward slightly and raise the lever located
on the outer portion of the seat. Slowly and carefully lean back to the desired
angle and release the lever. After ...
Jump starting
Jump starting can be dangerous if done
incorrectly. Therefore, to avoid harm to
yourself or damage to your vehicle or
battery, follow these jump starting procedures.
If in doubt, we strongly r ...
Before starting
Close and lock all doors.
Position the seat so that all controls are easily reached.
Adjust the inside and outside rearview mirrors.
Be sure that all lights work.
Check all gauges.
Check ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
